Tuesday, December 2, 2014

Limit switches for the ShapeOko2.

Yesterday I have finished installing limit switches on the ShapeOko2 I have.

I bought these switches at RS.com and fixed them to the machine using nylon cable ties. For the Z axis I used also these pieces bought from Inventables.com plus a few M5 screws, washers and nuts. Please see the pictures below.

The switches were wired in the NC position.



















  1. Hi Eduardo, your build looks great!! I was wondering if you could explain how you wired your limit switches. I have the same ones but I'm not very good at reading electrical diagrams. Thanks!

  2. Hi Brigette! Sorry for the long delay. Could you do it?